Hi everyone!


This article will show you how to use and control the LED Light feature on the FMBooth software.


Are you ready to have some fun? Let's begin!



TABLE OF CONTENTS


General settings - Connect to the LED Device:

1. Enable the BlueTooth connection for your iPad.


2. Open the FMBooth software > Global Settings > Bluetooth > press Selected Device and select the available LED device.





Software settings:

  • In your desired workflow, add a new Feature state to your workflow called LED Start to start the LED Light and locate it in the desired location in your workflow.
  • Set the desired LED Light Pattern (Solid, Rainbow, Spin, Fill, Fill Repeat, or Flash)
  • Set the light's Strength setting and Color from the color palette 



*If you wish to stop the LED light, you can add LED Stop feature state.



In the following workflow, you can see that we have LED Light turned on throughout the preset's session. A combination of Solid colors Rainbow, and a Flash after the photo is taken.**


**It is recommended to use a solid white LED light during countdown and while the photo is taken for better photo quality.





That's it! Super easy and super cool!